Page 1 of 1
Return edge?
Posted: 2017-09-04 06:59:38
by Hotel
Looking for some guidance on trimming the chest and back plate. My TK has a return edge on some parts, but not all. Does the TIE have a return edge? Before I trim too much, better to ask. Working with a WTF kit.
Re: Return edge?
Posted: 2017-09-04 16:08:21
by CR131
Yes, it does but it's only maybe a 1/8 of an inch or less.. very small..
ANH TIE Pilot TI-13175
Re: Return edge?
Posted: 2017-09-04 16:12:35
by CR131
Mine varies slightly but I hope this helps..
ANH TIE Pilot TI-13175
Re: Return edge?
Posted: 2017-09-04 20:15:26
by Hotel
I ended up trimming it all off. Hope this isn't a problem...
Re: Return edge?
Posted: 2017-09-05 06:18:51
by geordietrooper
screen used has a return edge
and you would need it if you wanted to put rubber trim on
Re: Return edge?
Posted: 2017-09-05 10:30:15
by CR131
The CRL doesn't specify a return edge and it probably won't be noticable on submission pictures but I would check with the GML if you want to verify if it'll be a problem..
ANH TIE Pilot TI-13175
